How to Install Butcher Block Countertops

Facts About How to Build & Seal Wood Countertops - Houseful of Handmade Revealed

Once all the pieces are taped in place, mark all the joints in between strips with recommendation lines that run throughout the seam of the adjacent pieces. Utilizing a hot glue weapon, thoroughly secure each crossway, ensuring to realign the reference marks. When the glue is dry, untape the template, then thoroughly fold it up and send it to the maker with your butcher-block order.

Also send out along manufacturers' item specification sheets (offered online). 5. Prepare the Cabinets If you're dealing with open-topped cabinets, you'll need to install blocking so there's something to screw the butcher block to. Utilizing a handsaw, cut plywood or 1x scrap to fit securely within the width of the cabinet.

Excitement About How to Install Wooden Countertops - (A DIY Guide!) - The

Fit the blocking in location at the front of the cabinet. Protect it to the cabinet with 1-inch deck screws through the pilot holes. If your cabinets have solid tops, it's best to glue down furring strips in order to develop an air space below the countertop and prevent it from cupping in scenarios where humidity swings are a problem.

Butcher Block Countertops - The Pros and Cons - Bob Vila

Lay these strips every 16 inches across the cabinet tops, sticking each down with a bead of cooking area and bath sealant. To make an angled pilot hole in the blocking, first drill a little starter hole straight down, then pull the bit out and rearrange it at an angle in the hole.

How Much Does It Cost To Install A Butcher Block Countertop? Things To Know Before You Get This

Connect the Butcher Block Using a drill/driver fitted with a -inch paddle bit, drill through the center of the blocking or through the solid cabinet top at one furring strip. Develop one hole like this on each cabinet. When making  Try This  in the cabinets, keep the bit from burning out the wood around the hole by securing a scrap block of wood against the cabinet top.

Tighten Down the Block From inside the cabinet, drive a deck screw fitted with a fender washer up through each hole, into the butcher block. (Ensure the screw is shorter than the counter is thick.) Tighten up the screw till it simply pulls the block snug to the cabinet. These screw "clamps" will permit the countertop to slightly move and prevent the butcher block from separating, splitting or splitting as the wood expands with humidity.